Anti-vibration wall mountings to prevent structural transmission through walls. Highly recommend to achieve structural stability of double-leaf walls, and at the same time prevent unwanted sound transmission to adjacent rooms. These units are a must when building walls with sizable dimension.
RWM1.01 and VicVibro RWM1.02 solutions are the only insulators on the
market with the double insulation function allowing the absorption of
walls bulging and the sound pressure of the inside. They are designed so
that the extension bracket works freely in the compression of the
rubber in both directions, assisting its performance in reducing
- Our VicVibro RWM1.03 and VicVibro RWM1.04 solutions are
made up of two parts: an elastic EPDM rubber cylinder and a steel
bracket. The insulator fixed to the wall with a screw that passes
through the elastic component. The insulator is extremely efficient
because it absorbs compression from the inside (sound pressure) and the
outside (compression caused by weight of the plasterboards...),
improving performance at low frequencies by preventing the possibility
of the rubber being stretched.
The first unit
should be applied 1,50m from the floor. The second unit should be
applied 3,00m from the floor. So on and so forth. The last unit should
be applied between 10-30cm from the acoustic ceiling. Remember that the
installation of the wall mountings should be in a criss-cross sequence
(please see the installation procedure sheets).